Ask Joe

29
Agonizing Reprise Q: Good Morning Joe, I just read “Agonizing Over Anodizing” in the September/October issue of Powder Coated Tough and I...

Read More...

10

Joe Powder is our technical editor, Kevin Biller. Please send your questions and comments to Joe Powder at askjoepowder@yahoo.com

Read More...

25
Good Morning, Joe,
I read your section in the Powder Coated Tough magazine and appreciate your knowledge and expertise. I have a couple questions about super-durables. I’ve talked with many of the leading suppliers of powder coatings and get the same answer from each one on this question.

Read More...

17

Q: Hey Joe,
I am looking at a report that a major company just sent in. The steel parts are showing signs of rust after 24 hours and visible signs of rust after 48 hours in a 5% salt fog solution.

Somewhat new to this world of powder coating – how is this possible? Some holes and slots that have been punched out I can somewhat understand. But when I see aluminum wheels and outdoor items holding up season after season I would have thought the powder coating would hold up longer?

Is there a method of correlation between hours in a salt chamber and what this means to user conditions?
Thanks,
John D

Read More...

24

Each issue, we take the padlock off the PCI® Test-Lab door for a few minutes so our favorite technical editor and “powder guru” Joe Powder can run in the yard. When he’s not gnawing on a rawhide bone, he loves to answer readers’ questions. Go ahead and send him one at askjoepowder@yahoo.com... he doesn’t bite. Maybe it’ll end up in the next issue!

Read More...

26

Each issue, we take the padlock off the PCI® Test-Lab door for a few minutes so our favorite technical editor and “powder guru” Joe Powder can run in the yard. When he’s not gnawing on a rawhide bone, he loves to answer readers’ questions. Go ahead and send him one at askjoepowder@yahoo.com... he doesn’t bite. Maybe it’ll end up in the next issue!

Read More...

29

Each issue, we take the padlock off the PCI® Test-Lab door for a few minutes so our favorite technical editor and “powder guru” Joe Powder can run in the yard. When he’s not gnawing on a rawhide bone, he loves to answer readers’ questions. Go ahead and send him one at askjoepowder@yahoo.com... he doesn’t bite. Maybe it’ll end up in the next issue!

Read More...

27
Q Joe, I work for an overhead doors company and we powder coat the extruded aluminum rails for our full-view doors. We have had issues in the p...

Read More...

Posted in: Ask Joe
03
Q Dear Joe, Waterjet metal cutting uses silica sand (silicon dioxide SiO2). Will this type of silicon cause adhesion problems and fish eyes? I ha...

Read More...

Posted in: Ask Joe
24
In a Haze Question: Howdy Joe, I am sorry if this email might cause you any inconvenience. At present, we are dealing with a finished powder coat...

Read More...

Page 2 of 5First   Previous   1  [2]  3  4  5  Next   Last